C39V2 AK Populated Pistol Project Barrel w/Receiver Stub and Bullet Guide, 12.25", Nitrided, 7.62x39, *Very Good Bore* Sold *AS IS*

SKU
BBL-17445
Out of stock

C39 Project Pistol Barrel with Receiver Stub, 12.25", Nitrided, Milled, 7.62x39, *Very Good Bore* Sold *AS IS* with no returns accepted.

Sold Individually.
Populated barrel with nitrided black finish.
Includes barrel,torch cut receiver stud with bullet guide, stripped rear sight, front sight / gas block combo, and handguard retainer.
Extractor cut, rear sight block cut, handguard retainer cut, front sight block cut, and gas port drilled.
The rear pin is missing from the front sight block and the front pin was set through the barrel bushing lock pin, fixing it in place.
The barrel bushing lock pin is stuck, and will most likely need to be ground off to allow a muzzle device.
The rear sight block pin is partially pressed (as pictured).
The bore is in Very Good condition, possibly Unused.
Because this is a project barrel, it will be sold AS IS and returns will not be accepted.
Shows some light signs of wear.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 12.25 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.

C39V2 AK Populated Pistol Project Barrel w/Receiver Stub and Bullet Guide, 12.25", Nitrided, 7.62x39, *Very Good Bore* Sold *AS IS* with no returns accepted.

Sold Individually.

Great parts for your next project!
Populated barrel with nitrided black finish.
Includes barrel, torch cut receiver stud with bullet guide, stripped rear sight, front sight / gas block combo, and handguard retainer.
Extractor cut, rear sight block cut, handguard retainer cut, front sight block cut, and gas port drilled.
The rear pin is missing from the front sight block and the front pin was set through the barrel bushing lock pin, fixing it in place.
The barrel bushing lock pin is stuck, and will most likely need to be ground off to allow a muzzle device.
The rear sight block pin is partially pressed (as pictured).
The bore is in Very Good condition, possibly Unused.
Because this is a project barrel, it will be sold AS IS and returns will not be accepted.
Shows some light signs of wear.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 12.25 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.


More Information
SKU BBL-17445
Weight 2.667000
Length (Dimension) 14
Height (Dimension) 1.38
Width (Dimension) 3.5
Country of Manufacture United States
Type Steel
Finish NiBX (Nitride)
Manufacturer Made in the USA
Condition Very Good
Stamped/Milled Milled
Color Black
Condition As-Is
Barrel Length 12.5"
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account