Egyptian Port Said M45 Parts Kit, w/Barrel, Side Folding Stock and Torch Cut Demilled Receiver Pieces, 9X19 *Very Good*

Egyptian Port Said M45 Parts Kit with live barrel, torch cut demilled Receiver sections, side folding stock, no barrel trunnion, 9MM NATO/9X19 Luger in *Very Good* condition.

Sold as a Kit.

These are great parts kits to add to your collection!
This is an original Egyptian Port Said parts kit, NO barrel trunnion, NO extractor, NO magwell, NO hoop guide pin, NO end cap, NO recoil spring.
Include torch cut section's of the receiver and small sections with the rear sight and sling swivel.
Location of torch cuts on receiver pieces will vary.
Wood grips and side folding stock.
Barrel shroud with front sight, may NOT have sling swivel.
8 inch long barrel with some light wear in the bore.
May show signs of wear, marring, scratches, grime, surface rust, etc...

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 8 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA. 

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.