Egyptian Port Said M45 Parts Kit, w/ Barrel, Side Folding Stock & Torch Cut Demilled Receiver Section, 9X19 *Very Good*

Egyptian Port Said M45 Parts Kit, with live Barrel, side folding stock and Torch Cut Demilled Receiver front section, no end cap, cut trunnion, 9MM NATO/9X19 Luger in *Very Good* condition.

Sold as a Kit.

These are great parts kits to add to your collection!
This is an original Egyptian Port Said parts kit, torch cut barrel trunnion, NO extractor, NO magwell, NO hoop guide pin, NO end cap.
Include torch cut section's of the receiver (with some overlap) and small sections with the rear sight and sling swivel.
Location of torch cuts on receiver pieces will vary.
Issue 9MM barrel has moderate wear in the bore.
May show signs of wear, marring, scratches, grime, surface rust, etc...

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 8 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA. 

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.