Thompson 1928A1 Barrel Assembly, 10", .45 ACP, with HG Mount, Proof Marked, *Very Good*

Thompson 1928A1 SMG Proof Marked Barrel Assembly, 10", .45 ACP, with receiver front section and HG mount, in *Very Good* condition.

Sold Individually.

These are great barrels to fit your Thompson!
Blued with the smooth profile, these barrels have the grip mount and receiver section attached.
Compensator is Not included.
Front of Receiver only, no other pieces included.
These barrels have a fair amount of rust pitting towards the muzzle end of the barrel.
Bore is in *Very Good* condition, with little to no signs of use.
May show some light signs of wear, marring, surface rust on exterior, etc...

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 10 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA. 

Parts must be inspected and tested by qualified and competent gunsmiths or armorers before use in a firearm.
Not all firearm parts are interchangeable; use of new parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.