AK-47 Barrel for Milled Receivers, 11.5", Surface Rust, Good Bore, 7.62x39 Irregular Journal Dimensions, In the White, US Made 922(r) Compliance Part *Good*

Original US Made AK Pistol Barrel, 11.5 inches long, 1960s Pattern, Drilled Gas Port, Irregular Journal Dimensions, In the White Finish, 922(r) Compliance Part, 7.62x39, in *Fair* condition.

Sold Individually.
Includes the barrel only (as pictured).
Approximately 11.5 inches long with an In the White finish.
These are 1960s pattern AK barrels for use with milled receivers.
Gas port hole is drilled.
The journal dimensions will vary and will not be correct: some will require milling (removing) and some will require adding material before proper fitment.
Barrel bore is in *Excellent* and shows minor signs of wear.
Barrel exterior will show signs of surface rust.
Shows additional signs of wear, marring, grime, etc...

This counts as one (1) part towards 922(r) compliance.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 11.5 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

Parts must be inspected and tested by qualified and competent gunsmiths or armorers before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.