Colt M16A2 Commando (Marked) Parts Kit, Flat Top Upper w/ Carry Handle, 11.5" Barrel, 3-Round Burst, Colt N1 4-Position Carbine Buttstock, .223/5.56 *Very Good*

Colt M16A2 Commando (marked on mag well) Parts Kit, Flat Top Upper with Carry Handle attached, 3-Round Burst Marked Receiver piece, 11.5" Barrel, Colt N1 4-Position Carbine Fiberlite Buttstock, 5.56 NATO in *Very Good* condition.

Sold Individually.

This is a great parts kit for your collection!
Complete less the receiver and burst fire cam.
11.5 inch long barrel with A2 birdcage style flash hider.
Saw cut 3-position (Burst, Semi, Safe) section of the lower receiver is attached to the butt stock assembly.
Magazine well with markings is attached to the upper at the pivot point.
4-position fiberlite (non-metal) carbine stock is marked "N" and "1" underneath the latch.
Original Colt carry handle assembly with A2 windage and elevation adjustable sight.
Standard M4 style handguards.
Barrel is marked "C MP CB" for Colt Magnetic Particle Chrome Bore.
Chrome lined bore shows moderate signs of wear.
Shows some light signs of wear and use.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 11.5 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

These parts have been taken from fully automatic weapons, and no modifications have been made for semi-automatic.
Modification may be required to function correctly and safely in a semi-automatic rifle.

Parts must be inspected and tested by qualified and competent gunsmiths or armorers before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.