M4 Commando Parts Kit, 11.5" HBAR, Colt M16A2 Commando Lower, 3-Round Burst, .223/5.56mm

M4 Commando Parts Kit, 11.5" HBAR, Colt M16A2 Commando Lower, 3-Round Burst, .223/5.56mm

Sold Individually (you will receive the kit pictured).

A great kit to add to your collection!
Complete less the receiver.
Flat top upper reciever and 11.5" heavy barrel are unknown manufacturer.
Saw cut 3-position (Burst, Semi, Safe) section of the lower receiver is attached to the buttstock assembly.
Colt adjustible fiberlite (non-metal) carbine stock.
Smith & Wesson quad rail handguards.
"C" marked Colt bolt carrier assembly with forward assist serrations.
Forward section of lower receiver is marked "Colt M16A2 Commando".

Bore shows moderate signs of wear.
Shows some light signs of wear and use.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved. An 11.5 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

These parts have been taken from fully automatic weapons, and no modifications have been made for semi-automatic. Modification may be required to function correctly and safely in a semi-automatic rifle.

Parts must be inspected and tested by qualified and competent gunsmiths or armorers before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.