Beretta M38/44 Barrel, w/ Receiver Section, Ring In Bore *As Is*

Original Italian Beretta M38/44 barrel, 9", with receiver section, Cut Magwell, Ring in Bore, 9x19, in *Good* condition.

Sold Individually.

These are great replacement barrels for your Beretta!
These barrels are 9" in length and are set into a cut section of the receiver.
The magwell and trunnion are most likely cut through.
Length and cut of receiver section will vary.
The barrel has a ring or multiple rings / bulges in the bore.
May show signs of wear, marring, scratches, surface rust, grime, etc...

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 9 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA. 

Parts must be inspected and tested by qualified and competent gunsmiths or armorers before use in a firearm.
Not all firearm parts are interchangeable; use of new parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.