BFT47 AK Populated Barrel, w/ Trunnion & Bullet Guide, No Bayonet Lug, 16", Phosphate, US 922(r) Compliant, 7.62x39 *Unused*

BFT47 AK Populated Barrel with Trunnion and Bullet Guide, No Bayonet Lug, 16 inches long, Phosphate finish, US 922(r) Compliant Parts, 7.62X39, in *Unused* condition.

Sold Individually.

16" length populated 1:10 twist chrome-moly 4150 steel barrel, all parts US made and assembled.
Barrel with trunnion, stripped front sight, stripped rear sight, gas block and handguard retainer.
These will have a phosphate finish.
Has extractor cut, the gas port is drilled, all parts fitted and barrel pin notch is made.
This barrel is still fitted to the trunnion, with a torch cut section of the stamped receiver.
The pins may be missing from the gas block or front sight block.
The bulged front trunnion will fit in a standard bulged trunnion AK receiver (RPK / Yugo), but the trunnion swells will not fill the bulged trunnion cutout space, so there will be an empty area.
The barrel assembly is SAAMI specification.

The barrel and trunnion count as two parts towards 922(r) compliance.

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.