C39V2 Pistol Barrel and Receiver Stub, 10.5", threaded muzzle, Nitrided, 7.62x39 *Excellent* 922(r) compliant part

C39V2 pistol Barrel and torch cut Receiver Stub, 10.5" long, 7.62x39,*excellent*, nitrided, 922(r) compliant part.

Sold Individually.

Great replacement parts for your AK!
Nitrided finish.
Extractor cut, rear sight block cut, handguard retainer cut, front sight block cut, and gas port drilled.
The newly made bullet guide is riveted into the front stub.
Parts were installed onto the barrel, then removed before gun was completed.
We do not have any of the external dimensions.
Shows some light signs of handling wear.
The barrel will count as one part toward 922(R) compliance.

NOTE: Prior to installing this length of barrel into a rifle a NFA Form 1 must be completed and returned approved.
A 10.5 Inch length barrel installed into a shoulder fired firearm is a "Short Barreled Rifle" under the NFA.

Parts must be inspected and tested by a qualified and competent gunsmith or armorer before use in a firearm.
Not all firearm parts are interchangeable; use of surplus parts without proper knowledge could cause a firearm to malfunction and cause property damage, injury or death.